The World’s Most Reliable Water Coolers USER’S MANUAL Model: A10-TL Please read the manual carefully before opera ng your water dispenser. Retain it for future reference.
A. SAFETY PRECAUTIONS 1 B. FUNCTION INTRODUCTION 2 C. PART NAME 3 D. OPERATION INSTRUCTION 4 E. CAUTION 4 F. 6 G. 6 H.
A: SAFETY PRECAUTIONS Warning: Do not damage the refrigerant circuit. The water cooler shall plug into a ground fault interrupter receptacle.
This appliance can be used by children aged from 8 years and above if they have been given supervision or instruc on concerning use of the appliance in a safe way and if they understand the hazards involved. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised. Keep the appliance and its cord out of reach of children aged less than 8 years.
C: PART NAME 1 2 3 4 10 5 11 6 7 8 12 13 9 14 SIDE NO. PART NAME NO. PART NAME Bo le Receptacle Drip Tray Top cover Cooling switch Cold Water Bu on Hea ng switch Room Temperature Water Bu on Power supply cord Hot water Bu on Drain Outlet Cold Water Spout Condenser Room Temperature Water Spout Hot Water Spout NOTE: This machine is suitable for both 3 or 5 gallon bo les. Do not use hard water.
C: OPERATION INSTRUCTION 1. Remove any s cker or label from the opening or cap of the bo le. 2. Ver cally insert the bo le into the bo le receptacle on top of the machine. Don't plug the power cord or turn on the hea ng or cooling switches un l water is dispensed from the hot and cold water spouts. 3. Insert the plug to into an electrical outlet. 4. Dispense a drop of water from both the hot and cold spouts to ensure the inner tanks have water in them. 5. Turn on the hea ng and cooling switches. 6.
4. In case when not using this machine for a long me, turn off the switches, then pull the plug out from socket and drain the remaining water through draining outlet 5. Never use organic liquid to clean the machine. Strictly prohibit using water to the splash it。 6. If the power cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard 7. Never turn the machine upside down or lt it more than 45℃ 8.
F: TROUBLE SHOOTING Please check the followings before having the machine repaired. PROBLEMS POSSIBLE CAUSES ELIMINATION 1. Just wait a moment ,for hot/cold water to be available again. 2. Connect plug to socket, turn on hea ng and cooling switch 1. Replace it with another one 2. Clean out wasted paper & bo le seal, install bo le again. No hot or cold water 1. Over consump on of hot or cold water in short me 2. No power supply No water running out from taps 1. Empty bo le 2.
3. To Remove Mineral Deposits: Mix 4 liters water with 200g citric acid crystals, inject into the machine and make sure the water can flow out of the hot water tap. Switch on the hot switch and heat it about 10 minutes. A er 30 minutes, drain out the liquid and clean it with water two or three mes as per the cleaning and draining instruc ons. Generally this should be done every six months. Never disassemble this machine by yourself to avoid danger from damaged machine. 5.
