Use and Care Manual

Prepare to assemble the table base by placing Lock Washers G on

all 8 Bolts E. Consult the diagram for proper alignment and

orientation of each support piece.

Align the hole in the end of 1 Top Support B with the hole at the

corner of 1 Frame Side A. Orient the Top Support so the 2 tabs

along the length are at the top edge and facing toward the inside as

shown. Connect the two pieces using a Bolt+Lock Washer E+G.

Tighten gently using the Hex Key H.

Join the opposite end of the Top Support to the other Frame Side

using a second Bolt+Lock Washer. Tighten gently using the Hex

Key. The table frame should now stand on its own as you connect

the remaining supports as shown.

Once all 8 joints have been connected with a Bolt+Lock Washer,

fully tighten all hardware using the Hex Key.

ASSEMBLY

Hardware Used: E

Bolt (M8x35mm)

x 8

Lock Washer

x 8

Place the Tabletop

D upside-down on a level surface.

Carefully turn the assembled table frame upside-down (so the tabs on the

Top Supports are at the bottom of the frame) and place it on the Tabletop.

Align the 4 tabs with the 4 holes in the Tabletop.

Insert a Bolt F through each tab and into the Tabletop. Tighten with the

Hex Key.

Check that all hardware is securely fastened.

Hardware Used: F Bolt (M6x12mm) x 4

Carefully turn the assembled table upright.

Your Tribeca Console Table is ready for use!