Full Product Manual

asseMBlY

Locate the hole in the middle of the bottom edge of each Divider C

and insert a Dowel H into each middle hole. Turn the Bottom Shelf B

upside-down. (Hint: the bottom of the shelf has 4 groups of 4

closely-grouped holes plus 6 single holes drilled in the surface.)

Align the

Bottom Shelf so it slides onto the Dowels inserted earlier.

Secure the Bottom Shelf to the Dividers

by inserting 6 Screws G as

shown. Tighten using a Phillips-head screwdriver.

Install the Legs D by aligning the holes drilled in each Leg's support

plates with the holes drilled in the Bottom Shelf B as shown. Insert

a Screw I in each hole and tighten using a Phillips-head

screwdriver.

Check that all hardware is firmly tightened, then carefully turn the

unit upright. Your Tribeca Media Console is ready for use.

Hardware Used: E Cam Lock Nut x 6

F Cam Bolt x 6

H Dowel x 3

Hardware Used: G Screw (M4x40mm) x 6

H Dowel x 3

Turn the Top Shelf A upside-down on a soft, nonabrasive surface.

Insert the threaded ends of the Cam Bolt F into the 4 holes near each

corner of the Top Shelf and into the 2 holes halfway down the long

sides of the Top Shelf. Tighten each Cam Bolt using a Phillips-head

screwdriver. In the remaining 3 holes in the Top Shelf, insert Dowels

H. Be sure the Dowels are firmly inserted by gently tapping with a

rubber mallet.

Find the 2 larger holes drilled near the corners of the surface of each

Divider C and insert Cam Lock Nuts E into these holes. Rotate the

Cam Lock Nuts so the small arrow on each points toward the adjoining

hole in the edge of each Divider . Orient each Divider so the Cam Lock

Nuts are closest to the Top Shelf, then slide each Divider over the Cam

Bolts/Dowels installed earlier and ensure the Dividers sit flush with the

Top Shelf.

To secure the Dividers, turn the Cam Lock Nuts clockwise with a

Phillips-head screwdriver until tight.