Owner's Manual
12
Leveling the Ice Maker
The ice maker should be installed on a rm and level surface that will be
able to support the enre weight of a fully loaded unit. It is important
for the ice maker to be leveled in order to work properly. It can be
raised or lowered by rotang the feet on the boom of the machine. If
you nd that the surface is not level, rotate the feet unl the ice maker
becomes level. You may need to make several adjustments to level it.
We recommend using a carpenter’s level to check the machine. Turn
the leveling feet to the right to lower that side of the ice maker. Turn the
leveling feet to the le to raise that side of the ice maker.
Important: Once you are ready to install the unit in a cabinet or directly on the oor, you must
adjust the feet to level the ice maker.
!
Installing the Door Handle
Cauon: Do not over-ghten the screws as this may cause damage to the handle or to the door.
!
To install the door handle:
1. Open the door and carefully pull out the secon of the door gasket that covers the hole where the handle
is to be installed.
2. Insert each Phillips head screw through the hole on the inside of the door unl the screw passes through to
the outside of the door.
3. Align the handle with the screws and ghten using a Phillips head screwdriver unl the handle is ush
against the door frame.
4. Carefully press the door gasket back into its original posion.
Down
Up
Note: Panel ready models allow for the installaon of dierent handles, which may be axed to
the panel overlay directly. Door handle installaon may be dierent than the above instrucons.