Owner’s Manual Undercounter Beverage Refrigerator Models: ABR152SGRH / ABR152SGLH www.avallon.com V1.
Important Safety Information Improper handling can cause serious damage to the Avallon refrigerator and / or injury to the user. This refrigerator is designed for domestic indoor use only. Do not use the unit for industrial or commercial use. Any other use may invalidate the warranty. Please review the rating label located inside and on the rear panel of the unit for electrical and other technical data related to this unit. The unit must be used with a properly grounded wall outlet.
Import Safety Information General Safety ! • • • • • • • • • • • • • • • • • • • • • • • • • • To prevent injuries, use at least two people to move and install the refrigerator. This appliance is not intended for use by persons, including children, with reduced physical, sensory or mental capabilities, unless they have been given supervision or instruction concerning the use of the appliance by the person(s) responsible for their safety.
Table of Contents Important Safety Information.................................................................................................................................. 2 First-Time Operating Instructions............................................................................................................................ 5 Introduction.............................................................................................................................................................
First-Time Operating Instructions Before use, make sure all packaging labels and materials are removed from the unit. Be sure to keep track of all included parts and pieces before discarding the packaging materials. It is advised that you keep the original box and packaging materials in case you ever need to move or ship the appliance in the future. Let the unit stand for at least 24 hours before you use it; this allows the cooling components time to settle from transit.
Parts Identification Full View: Handle Stainless Door Door Lock Front Vent Leveling Leg Empty View: Carbon Filter RUN F Control Panel C Internal Fan Shelf 6
Back View: Ra�ng Label Cabinet Power Cord Carbon Filter: A built-in carbon filter protects your contents by acting as a natural barrier against harmful odors. Internal Fan: This is an air-cooled unit equipped with an internal fan that maintains a consistent internal temperature. Note: The carbon filter should be replaced every 3 - 6 months depending on the unit’s exposure level to odor. If the unit is placed in the kitchen, regular replacement every 3 months is ideal.
Installation The refrigerator should be installed in accordance with local electrical code requirements. The refrigerator should also be placed in a location that is strong enough to support its total weight, keeping in mind that it will weigh substantially more when fully loaded than when empty. Before you plug the refrigerator into a power supply, be sure to let it stand upright for at least 24 hours to allow the compressor’s oils to settle.
Clearance Requirements Notes: • To ensure proper service access and ventilation, allow between 1 - 2 inches of clearance at the back as shown in the diagram. • The installation should allow the unit to be pulled forward for servicing, if necessary. • A standard electrical supply (115 VAC only, 60 Hz), properly grounded in accordance with National Electrical Code and local codes and ordinances, is required. When installing the refrigerator under a counter, follow the recommended spacing dimensions shown.
Electrical Requirements ELECTRIC SHOCK HAZARD! • Plug into a grounded 3-prong outlet. • Never remove the grounding prong from the plug. • Never use an adapter to bypass the grounding prong. • DO NOT use an extension cord. • Failure to follow these instructions can result in fire, electrical shock, or death.
Leveling the Refrigerator The refrigerator should be installed on a firm and level surface that will be able to support the entire weight of a fully loaded unit. It is important for the refrigerator to be leveled in order to work properly. It can be raised or lowered by rotating the plastic sheaths around each of the feet on the bottom of the machine. If you find that the surface is not level, rotate the feet until the refrigerator becomes level. You may need to make several adjustments to level it.
Installing the Shelves To prevent damaging door gasket, make sure to open the door fully before pulling the shelves off their tracks. 1. Open the door completely. 2. Ensure that the metal guide posts are attached to the back of the shelf. 3. While lifting the right side of the shelf up 45°, rest the left metal guide post on the shelf track. 4. Slowly push the shelf back until the right metal guide post reaches the vertical indentation in the cabinet. 5. Gently set the shelf down on the track.
Operation Installation Checklist before Operation 1. Have all packing materials and tape been removed from the interior and exterior of the refrigerator? 2. Have the installation instructions been followed, including connecting the machine to electricity? And has proper grounding been installed for the refrigerator? 3. Has the machine been leveled? 4. Is the refrigerator in a site where the ambient temperature is between 50° F and 90° F all year round? 5.
Sabbath Mode This refrigerator is programmed with a Sabbath Mode. In Sabbath Mode, the refrigerator will continue to cool and maintain temperature. However, the refrigerator will no longer respond to user interactions. All lights, display(s), and indicators are turned off, and all alarms are disabled. To enter Sabbath Mode, hold the Power button and press the Up button twice. The control panel will beep twice indicating that the refrigerator is in Sabbath Mode.
Normal Sounds Your new refrigerator may make noise during normal operation. Most of these sounds are normal. Hard surfaces like the floor and walls can make the sounds seem louder than they actually are. The following describes several sounds you may hear and what may be making them: • Rattling noises may come from the flow of the refrigerant or the water line. Items stored on top of the refrigerator can also make noises. • The high efficiency compressor may make a pulsating or high-pitched sound.
Preparing the Refrigerator for Storage If the refrigerator will not be used for a long time, or is to be moved to another place, it will be necessary to defrost the unit and dry the interior. 1. Disconnect the refrigerator from the power supply by removing the power plug from the wall socket. 2. Leave the door open to allow for air circulation and to prevent mold, mildew, and unpleasant smells. 3. Once the interior is dry and clean the unit will be ready for storage.
Troubleshooting Before Calling for Help: If the unit appears to be malfunctioning, read through the “Operation” section of this manual first. If the problem persists, check the Troubleshooting Guide below and on the following page. The problem may be something that can easily be solved or explained. Symptoms The refrigerator turns on and off frequently. The refrigerator does not turn on. The refrigerator will not reach the desired temperature.
Symptoms The refrigerator is making strange noises. Solutions Read the “Normal Sounds” section. Check to make sure that the refrigerator is level, and that it is not in contact with another appliance or furniture. The body of the refrigerator is The unit is not grounded Contact your local electrician to test your electrified. properly. electrical grounding system. Frost is forming in the The environment is humid. Though the unit uses an “auto-defrost” refrigerator.
Specifications Note: Technical data and performance information are provided for reference only. Specifications are subject to change. Check the rating label on the refrigerator for the most accurate information. Product Type Undercounter Beverage Refrigerator Model ABR152SGRH/ABR152SGLH Voltage / Frequency AC 115V~60Hz Amperage 1.5 Color Black Cabinet with Stainless Steel Door Refrigerant R600a, 1.06 oz.
Product Warranty Warranty Period Avallon will be responsible for: Consumer will be responsible for: 1st year All costs for repairing or replacing parts and/or unit which proves to be defective. All transportation costs in the first 90 days. Consumer will be responsible for: All transportation costs after 90 days. Limited 2nd-5th year (compressor only) Repairing or replacing any compressor which proves to be defective. (Labor not included.) Labor and all transportation costs.
www.avallon.
