User`s manual
PAGE 3
Technical Support (650) 384-0000 www.avalanwireless.com
User’s Manual AW58100HTA, HTS
Quick Start Guide
To create a point-to-multipoint system, you need one AW58100HTA Access Point and
one or more AW58100HTS Subscriber Units. We recommend connecting and power-
ing up the units on the bench before deploying in the eld because it is much easier
to troubleshoot problems and to adjust the conguration if necessary without hav-
ing to climb poles to do it. Activate the AW58100HTS units one at a time until they
can be given distinct IP addresses.
Step 1. Gather the parts: In addition to the AvaLAN radios and the accompanying
AW-POE Power Over Ethernet Injectors and 12VDC power supplies, you will need
at least 2 CAT5 cables and a PC with a LAN connection. If desired, you may also
want a data source such as a surveillance camera with a TCP/IP interface. (You can
determine that the radios are communicating without an external data source by
browsing to the radio on the other side of the RF link from your PC.)
Step 2. Make the connections: Connect the devices as shown in the diagram. Do not
point the two radio antennas directly at each other because their close proximity
will overload the radio receivers. Place the radios at least 10 feet apart with their
antennas pointing in different directions. Plug in the power supplies to turn on the
radios.
Step 3. The default IP addresses of the radios are written on their product la-
bels. The address of the Access Point (master) is 192.168.88.12. The address of the
Subscriber Unit (client) is 192.168.88.10. You must congure your PC’s wired LAN
port to the same subnet and an IP address different from either of the above. With
this conguration in place, you should be able to use a web browser on your PC to
log in to each radio’s interface.
Access Point
Subscriber Unit