Manual

AW900mSPI
User’s Manual
PAGE 14
Technical support [phone] www.avalanwireless.com
Status Command
The getStatuscommandisusedtondoutthecurrentstatusofthemodule.
getStatus SPI Mode:
0x01
UART Mode:
0x00
Byte 1 b7 b6 b5 b4 b3 b2 b1 b0
RFState Radio - - CH3 CH2 CH1 CH0
RFState: When set this bit indicates that the RF is currently connected.
Radio: Indicates what mode the radio is in, when set it is in active mode. When
clear the RF is in standby mode.
CH3..0: Indicates what channel the RF is currently using.
The setStatus command is used to place the module in standby mode/normal op-
erationandtosettheRFintomanualchannelmodebyassigningaspecicchannel.
setStatus SPI Mode:
0x81
UART Mode:
0x80
Byte 1 b7 b6 b5 b4 b3 b2 b1 b0
- Radio - - CH3 CH2 CH1 CH0
Radio: Setting this bit places the radio in active mode, clearing it places it in
standby mode.
CH3..0: When these bits are cleared the radio is in automatic channel mode. When
any of these bits are set the radio will be in manual channel mode and use the chan-
nel indicated by these bits if it is valid.
Channel CH3 CH2 CH1 CH0 Frequency - MHz
1 0 0 0 1 903.1250
2 0 0 1 0 905.2083
3 0 0 1 1 907.2917
4 0 1 0 0 909.3750
5 0 1 0 1 911.4583
6 0 1 1 0 913.5417
7 0 1 1 1 915.6250
8 1 0 0 0 917.7083
9 1 0 0 1 919.7917
10 1 0 1 0 921.8750
11 1 0 1 1 923.9583
12 1 1 0 0 926.0417