Owner manual

AW2400mSPI
User’s Manual
PAGE 34
Technical support [phone] www.avalanwireless.com
appearingrst.
6. Thedropdown listlabeled "Boot Cong Serial Port" willoffer achoice of all
active USB Serial COM ports on your system. the one you should select is the
higher numbered of the two ports associated with the Evaluation Board.
7. Next,youhavethechoiceofloadingthebootcongurationfromaleorre-
trievingitfromtheAW2400mSPI.Asampleleisprovidedforyourconvenience
asEVK.conf.Thecongurationleisareadableandeditabletextle,butthe
easiest way to modify it is to load it with the utility, change what you wish in
thesetofbootcongurationparametersandthensaveitbacktoyourPC.
8. TheBootCongparametersareasfollows:
• Access Point (AP) or Subscriber Unit (SU) radio buttons. Set one Evaluation
Board to be an AP and the other to be a SU.
• Number of Subscriber Units if AP or Subscriber ID if SU. (An AP will support up
to 16 SUs at one time and their assigned IDs should be assigned consecutively
from 1 to n.) For the pair of Evaluation Boards, set both to "01".
• Channel: a two-digit number from 00 to 12, specifying the RF channel to
use or allowing automatic selection with the code 00. The AP and associated