Owner manual

PAGE 25
Technical support [phone] www.avalanwireless.com
AW2400mSPI
User’s Manual
code, here is how to do it.
The following information applies to SPI Mode only:
Once a setFirmwareStart (0x8B) command has been issued to the XC1220, all other
commands except for setPacket (0x8A) and setFirmwareEnd (0x8C) become in-
valid and will cause the Error Flag to assert if they are issued. The host microcon-
troller must deassert the /CS_BB line (pin 12) and then wait for a minimum of 5 µs
and the DATA Ready line (pin 9) to be asserted before reasserting /CS_BB to send
therstdatablock.
Thermwareimageispartitionedintodatablockswithapayloadsizeof64bytes.
Each block is sent as it’s own transaction and must use the setPacket command to
be issued to the XC1220. Since data can be submitted to the XC1220 faster than it
canbestoredinash,theFIFOFulllinemustbecarefullyobservedtomakesure
none of the blocks are lost.
Ifthelastrmwareblockisnotafull64bytes,itmustbepaddedwithzeros.
setPacket SPI Mode:
0x8A
b7 b6 b5 b4 b3 b2 b1 b0
Byte 1 BC ID6 ID5 ID4 ID3 ID2 ID1 ID0
Byte 2 S7 S6 S5 S4 S3 S2 S1 S0
Byte 3 - - - - - S10 S9 S8
Byte 4 OFS7 OFS6 OFS5 OFS4 OFS3 OFS2 OFS1 OFS0
Byte 5 OFS15 OFS14 OFS13 OFS12 OFS11 OFS10 OFS9 OFS8
Byte 6 DATA7 DATA6 DATA5 DATA4 DATA3 DATA2 DATA1 DATA0
Byte 7 DATA15 DATA14 DATA13 DATA12 DATA11 DATA10 DATA9 DATA8
...
Bytes 6 and 7 are repeated 32 times.
Byte 70 CHK7 CHK6 CHK5 CHK4 CHK3 CHK2 CHK1 CHK0
Byte 71 CHK15 CHK14 CHK13 CHK12 CHK11 CHK10 CHK9 CHK8
BC must be set and ID0 to ID6 must be clear. (Byte 1 is 0x80.)
S0 to S10 must be set to 68. (Byte 2 is 0x44 and Byte3 is 0x00.)
OFS0toOFS15isthe16-bitintegerrmwareblocknumber.Thisvaluewillbein-
cluded in the checksum calculation.
DATA0toDATA15isthe16-bitrmwaredata,32valuesperblock.