Owner manual

PAGE 11
Technical support [phone] www.avalanwireless.com
AW2400mSPI
User’s Manual
speciedtobeatleasttwointervals.Also,sometimesaParityBitissentbetween
D
7
and the Stop Bit, but this is rarely done anymore.
UART Mode LEDs and DIPs:
WiththeUARTrmwarerunning,theLEDdenitionsarethesameasforSPImode
and provide diagnostic information if desired.
TheDIPswitchdenitionsareslightlydifferent:
b7 b6 b5 b4 b3 b2 b1 b0
Byte3 DCH4 DCH3 DCH2 DCH1 DCH0 MODE -
Byte4 TEST
MODE: 1 = Access Point, 0 = Subscriber Unit
DCH4 to DCH0: 5-bit binary code for the RF channel selected. (All zeros means use
automatic channel switching.)
TEST:1=Continuoustrafcforsitesurveytesting,0=normaloperation.