User Manual
©2004 — 2007 AvaLAN Wireless Systems Incorporated. All rights reserved. AvaLAN Wireless and the AvaLAN Wireless logo are registered trademarks of AvaLAN Wireless Systems
Incorporated. All other trademarks are property of their respective owners. AvaLAN Wireless makes no representations or warranties with respect to the accuracy, utility, or
completeness of the contents of this publication and reserves the right to make changes to specications and product descriptions at any time without notice. No license, express
or implied, by estoppel or otherwise, to any patents or other intellectual property rights is granted by this document. Particular uses or applications may invalidate some of the
specications and/or product descriptions contained herein. The customer is urged to perform its own engineering review before deciding on a particular application. AvaLAN
Wireless products are not designed for use in medical, life saving, or life sustaining applications. 07.07.2007
support@avalanwireless.com
Technical support :: (650) 384.0000
For advanced installation information visit
www.avalanwireless.com
To fulll FCC certication requirements:
1. Integrator must ensure required text [Figure 1] is clearly placed on the outside of the nal product.
2. This device has been designed to operate with the antenna types listed below, and having a maximum gain of 23 dB.
3. The required antenna impedance is 50 ohms.
Table 1. Type certied antennae
Antenna warning
WARNING: This device has been tested with Reverse Polarity SMA connectors with the antennas listed in Table 1 Appendix A. When
integrated into OEM products, xed antennas require installation preventing end-users from replacing them with non-approved anten-
nas. Antennas not listed in the tables must be tested to comply with FCC Section 15.203 (unique antenna connectors) and Section
15.247 (emissions). To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for successful communication.”
IC (Industry Canada) Certication
Labeling requirements for Industry Canada are similar to those of the FCC. A clearly visible label on the outside of the nal product
enclosure must display the following text:
Integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B - Unintentional Radiators. ICES-003 is the
same as FCC Part 15 Sub. B and Industry Canada accepts FCC test report or CISPR 22 test report for compliance with ICES-003.
To fulll IC certication requirements:
1. Integrator must ensure required text [Figure 2] is clearly placed on the outside of the nal product.
2. This device has been designed to operate with the antennas listed below, and having a maximum gain of 23 dB.
3. Antennas not included in this list or having a gain greater than 23 dB are strictly prohibited for use with this device.
4. The required antenna impedance is 50 ohms.
Table 2. Certied antennae