User's Manual

PAGE 31
Technical support [phone] www.avalanwireless.com
MOD090-LP
User’s Manual
WARNING: WARNING: The FCC requires that all spread spectrum devices operating within the Unlicensed radio frequency bands must limit themselves
to a maximum radiated power of 4 Watts EIRP. Failure to observe this limit is a violation of our warranty terms, and shall void the user’s authority to
operate the equipment. This can be stated as follows:
RF power - cable loss + antenna gain <= 36 dBm EIRP
Fixed Base Station and Mobile Applications
AvaLAN Modules are pre-FCC approved for use in xed base station and mobile applications. When the antenna is mounted at least 21.05 cm (8”) from
nearby persons, the application is considered a mobile application.
Portable Applications and SAR Testing
When the module will be used closer than 21.05 cm to nearby persons, then the application is considered “portable” and requires an additional test
be performed on the nal product. This test is called the Specic Absorption Rate (SAR) testing and measures the emissions from the module and how
they affect the person.
RF Exposure
(This statement must be included as a CAUTION statement in OEM product manuals.)
WARNING: This equipment is approved only for mobile and base station transmitting devices. Antenna(s) used for this transmitter must be installed
to provide a separation distance of at least 21.05 cm from all persons and must not be co-located or operating in conjunction with any other antenna
or transmitter.
To fulll FCC Certication requirements:
1. Integrator must ensure required text [Figure 1] is clearly placed on the outside of the nal product.
2. AW900G2LP Module may be used only with Approved Antennas that have been tested with this module.
IC RSS-102 RF Exposure statement:
This system has been evaluated for RF Exposure per RSS-102 and is in compliance with the limits specied by Health Canada Safety Code 6. The system
must be installed at a minimum separation distance from the antenna to a general bystander of 31.2 cm to maintain compliance with the General
Population limits.
L’exposition aux radiofréquences de ce système a été évaluée selon la norme RSS-102 et est jugée conforme aux limites établies par le Code de
sécurité 6 de Santé Canada. Le système doit être installé à une distance minimale de 31.2 cm séparant l’antenne d’une personne présente en
conformité avec les limites permises d’exposition du grand public.
Antenna Pattern Type Gain
Omni directional Monopole ≤ 6dBi
Directional Yagi ≤ 15dBi
Directional Panel ≤ 10dBi
Type certied Antennas
IC (Industry Canada) Certication
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
Contains Model AW900G2LP Radio, IC: 5303A-AW900G2LP
Integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B - Unintentional Radiators. ICES-003 is the same as FCC Part
15 Sub. B and Industry Canada accepts FCC test report or CISPR 22 test report for compliance with ICES-003.
Transmitters with Detachable Antennas
This radio transmitter (IC: 1846A-XLRP) has been approved by Industry Canada to operate with the antenna types listed in AW900G2LP Approved
Antennas abov with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in
this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.
Le présent émetteur radio (IC: 1846A-XLRP) a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci?dessous et
ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain
est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur.
Detachable Antenna
Under Industry Canada regulations, this radio transmitter may operate using only an antenna of a type and maximum (or lesser) gain approved for
the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the
equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peutfonctionner avec une antenne d'un type et d'un gain maximal
(ou inférieur) approuvépour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillageradioélectrique à l'intention des autres
utilisateurs, il faut choisir le type d'antenne etson gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépassepas l'intensité
nécessaire àl'établissement d'une communication satisfaisante.