User Manual

PAGE 11
Technical support [phone] www.avalanwireless.com
User’s Manual AW5802mTR
To add a new SU to the AP, disconnect the AP from the network and power o.
Connect an Ethernet cable between the SU and AP. Power up the SU FIRST and then
the AP. The SU will receive the key. Disconnect the Ethernet cable and cycle power
on the SU to cause the new keys to take eect.
To re-key SUs to a new AP, proceed as in the inital setup, making sure to power up
the AP FIRST.
Technical specications
Characteristic Specication/Description
RF transmission rate 1.536 Mbps
Ethernet data rate 935 Kbps
Receiver Sensitivity -97 dBm at 10
-4
Bit Error Rate
Range Up to 30 miles line-of-sight with 22 dBi antennas
RF channels/bandwidth 59 non-overlapping with 2.048 MHz spacing and 1.75 MHz
bandwidth, automatic or manually selectable via web
browser interface
Connector types RF: RPSMA Female / 10/100 base T Ethernet: RJ-45
Data Encryption 128-bit AES, FIPS197, keys set through password-pro-
tected browser interface
Error correction technique Sub-block error detection and retransmission
Power regulation Built-in switching regulator
Browser management tools QoS Statistics, Network Settings, Spectrum Analyzer,
Firmware Upgrade
Power consumption Transmit: 2.2 Watts Receive: 1.2 Watts
Voltage 9 to 48 VDC via unused pins in RJ-45 jack - pins 4,5
positive, 7,8 ground
Power regulation Switching regulator
Transmit current draw 180 ma at 12 VDC
Operating Temperature Range -40 ºC to +80 ºC
Size 70 x 66 x 23 mm, 40 grams