User Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Controller Start-up
- Appendix A: Specifications
- Appendix B: Error Messages
- Appendix C: PCI Hot Plug
- Appendix D: Enclosure Management
- Warranty
General Hardware Specifications
A-2 AcceleRAID 170LP Installation Guide
Environmental Specifications
Controller AcceleRAID 170LP
Temperature Operating 0°C to +50°C (+32°F to 131°F)
Storage -20°C to +70°C (-4°F to +158°F)
Humidity Operating 10% to 90% relative humidity (non-condensing)
Storage 10% to 90% relative humidity (non-condensing)
Altitude Operating Up to 3,048m (10,000 ft )
Storage Up to 15,240m (50,000 ft)
Form Factor MD2 (Low
Profile)
Length: 6.6 inches
Width: 2.5 inches
Maximum
Component
Height:
0.105 inches on the solder side of the board
0.570 inches on the component side of the board
Typical Power
Consumption at 5.0V 15 watts, maximum
below 3A
MTBF above 250,000 hours at 55°C