User Manual
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Installation
- Chapter 3: Controller Start-up
- Appendix A: Specifications
- Appendix B: Error Messages
- Appendix C: PCI Hot Plug
- Appendix D: Enclosure Management
- Warranty
User-supplied Items
1-6 AcceleRAID 170LP Installation Guide
User-supplied Items
The following user-supplied items are required to perform this installation:
• IBM-PC™ compatible host system with PCI 2.2 compliant slot
• Network operating system software (as required)
• SCSI cables to connect the controller and disk arrays (when used in a
2U chassis server, a low profile cable connector may be required)
1
• Static grounding strap or electrostatic discharge (ESD) safe work area
• Disk array enclosure (or equivalent) with SCSI disk drives
1. It is recommended that you use an Amphenol® Fast 40 LVD,
round cable and a Hitachi ® twisted pair, flat cable.