Specifications

STEP3
STEP2
B6ABT
STEP1
STEP4
6.5” (165 mm) 2-Way Marine/Powersports
Roll Cage/Waketower Speaker Pods
Installation instructions
It is strongly recommended that you work with an assistant to install these speakers.
To adjust the mounting angle, loosen the metal
base of the mounting band by unbolting the two
screws.
Make sure to put all components of the mounting
hardware in a safe location.
Metal base
48 x 30mm rubber pad
Aluminum band
Rubber strip
Mounting cage bar
(part of your marine
boat or powersports
vehicle)
Metal base
Twist the metal base to determine the
optimal mounting angle for the speaker on the
cage bar. Then secure the metal base
by tightening the two screws.
Place a supplied rubber pad (48 x 30 mm) on the
metal base of the mounting band to prevent
abrasion and secure clamping.
Place two supplied rubber strips around the cage bar
to prevent abrasion and secure clamping.
Then push two supplied aluminum bands over the
cage bar, and align the aluminum bands with the
metal base on the speakers.
B6ABT
6.5” (165 mm) 2-Way Marine/Powersports
Roll Cage/Waketower Speaker Pods
As illustrated, secure the aluminum bands to the
metal base using a pair of M6 x 60mm screws,
M6 flat washers, and M6 locknuts. The locknuts
must be installed into the hex shaped recess on
one end of each aluminum band.
Hand-tighten the screws to the degree which
allows just enough freedom to rotate the speaker
around the cage bar.
Speaker installation now completes.
AUX input
Using the supplied 3.5mm audio cable, connect the speaker to your mobile phone for audio input to the
speakers. Make sure Bluetooth connection is not made to enable AUX input.
Bluetooth
Product dimensions
Through Bluetooth connection, you can stream music from a Bluetooth device (e.g. a mobile phone) to the
speakers. Make sure Bluetooth is enabled on the device. When the device is in Bluetooth range, it will
connect Bluetooth automatically and will be disconnected when it is out of Bluetooth range.
9.88”
(250mm)
7.19”
(182mm)
7.31”
(186mm)
mounting tube
diameter:
1.5” - 2”
(38-51mm)