User Manual

FAQs
www.avaccess.com 7

[e-mail]

FAQs
1. What should I do when Link LED is on, but there's no video output on the
remotedisplay?

• Check and ensure the Work Mode switches on both transmitter and
receiver(s)aresettothesamepositions(bothat"Wireless"or"Wire").

• Check and ensure the HDMI source is powered on, and the
transmitter'sHDMIInLEDison.

• ConnecttheHDMIsourcedevicedirectlytothedisplaytoseeifthere's
signaloutput.

2.
Howtodealwithpoorvideoquality?
• Check ifthe HDMIcables are connectedproperly. Usedifferent HDMI
cablesifnecessary.

• Change the angles of the antennas on transmitter and receiverto
makethe antennasparallelto eachother (referto Figa). Operation in
Figb&cisnotrecommended.

 