User Manual

www.avaccess.com [e-mail]
5
Introduction
Rear Panel
Transmitter
No. Name Description
1 DC 18V
Connect to the DC 18V 1A power supply.
Note: If transmitter is connected to the power supply, the
receiver is adapter free.
2 HDBT Out Connect to the receiver via a Cat 5e/6/6a/7 cable.
3 IR In
Connect to the supplied IR receiver. Secure the IR receiver
with adhesive.
4 IR Out
Connect to the supplied IR emitter. Secure the IR emitter
on the IR receiving sensor of source device with adhesive.
5 RS232 RS232 pass-through
6 HDMI In Connect to an HDMI source device.
1 2 3 4 5 6