9 10 Wait or reset the original setting. 11 16 17 Note: All the illustrations in this manual are for explanation purpose only. Your air conditioner may be slightly different. The actual shape shall prevail.They are subject to change without notice for future improuement.
1. Prepare a hole in the wall. Install the wall exhaust adaptor onto the wall by using 4 expansion screw sleeve and type C screws, be sure to fix thoroughly. 2. Connect the exhaust duct to wall exhaust adaptor.(Fig.G) Note: Cover the hole using the adaptor cap when not in use. Expansion screw sleeve position Adaptor cap Wall exhaust adaptor Adaptor B (round mouth) maximum:120cm minimum:60cm Fig.G Note: 1.The duct can be compressed to 270mm minimum and extended to 1500mm maximum.
Ambient light (only for some models) Function of magnetic remote control : If there is a “ Magnetic Holder ” indicator label near the control panel, the original remote controller can magnetically match the label area.
There are four kinds of control panel, Fig A, Fig B, Fig C and Fig D, the actual shape shall prevail. ●The customer should have a qualified power supply coincident with that printed on the tag of the air conditioner. ●Must use dedicated circuit and efficient grounding outlet matching with the plug of the air conditioner. ●The appliance should be installed in accordance with national wiring regulation. ●The plug should be easily accessible after installation. 1.
Press this button to turn the unit on or off. Expansion screw sleeve(#), Type C Screws(#) 4pc 4pc The actual shape shall prevail.They are subject to change without notice for future improuement. opening angle use it. opening angle use it.
9. Press and hold the “ ” button for 5 seconds，the WI-FI turn on for matching and the ambient light blinks white，it stops when the time is over 10 minutes. After the WI-FI is successfully connected, the ambient light is fixed white for 10 seconds, and then it restores previous display status. 10. Child-lock (only Fig D) Press the “ ” and “ ” buttons at the same time and hold for at least 3 seconds to activate or deactivate the child-lock function. 11.
