User`s manual

AuviTran Network ASIO Streamer 6
3.2 Configuration of an AVM500-ES
The ports C, D and E of an AVM500-ES can each be configured for ASIO streaming, either separately or together. Only the
port C of and AVM500-ES/3ports can be configured for ASIO streaming. A physical port cannot be used for both ASIO and
EtherSound access: activating the ASIO streaming mode will disable the EtherSound traffic on that port.
3.2.1 Activating the ASIO streaming mode
Select the port for which you wish to activate ASIO streaming. Go to the Control tab, open the port setup panel and then:
1. dissociate the port
2. configure it as an „In‟ port:
3. enable ASIO mode
Activating the ASIO mode will automatically disable 3
rd
port access and consequently make the selected port disappear from
the network.
Connect the port to the PC (use a switch to connect both the ASIO port and the 3
rd
port of the AVM500-ES to the PC). The
port is visible again in AVS-ESMonitor.
Notice: make sure to set the port to „In‟ mode before connecting it to the host PC or to a
switch. Failure to do so will cause EtherSound traffic to be broadcasted and will have a
severe impact on the network‟s performance and stability.