User`s manual

13-2 Menu
Menu is organized that way:
Menu Submenu Function
File New Erase current configuration from
memory, and start new session
Load… Load a configuration previously saved
to a file
Save Save current configuration to opened
file
Exit Exit ES-Editor
Help About Display ES-Editor version
13-3 How to build a new configuration
Building a configuration is done via drag and drop. User selects which device to add to
your configuration from Device selector, and drags it to right place on the Network
building side. Device will be automatically added to the configuration.
If device is dragged over an empty place, a new network will be created with device set
as Primary Master.
In the bottom part of the interface, user can:
• Change device MAC Address
• Change device alias
13-4 How to edit a configuration
Editing a configuration is done by right clicking on devices, and using drag and drop.
After successful loading a previously created file, Network building will be updated with
data contained within the file.
Using drag and drop, user can move part of created EtherSound network from one place
to another.
Right clicking on device will allow user to delete selected device, or delete selected device
and whole its child.
13-5 How to use generated configuration
After successful building or editing configuration, user has to save it into a file by using
the command “Save” from the file menu.
Afterwards, this configuration can be imported in AVS-ESMonitor both in online or offline
mode.
AVS-ESMonitor – User’s Manual AuviTran 38