User`s manual

11-8 Network Routing Page
Network routing page gives the user the ability to directly assign a device input to a
device output. Software will perform automatically, if possible, the EtherSound sub-
routing needed to match user desire. If required and available, bi-dir mode will be set on
devices by software.
Global Collapse/Expand button
Collapse button
SRC2 is routed to RCV6
Current selection
ES Channel summary icons
Routing not available
No routing done
Expand button
Network Routing page overview
When routing is available, a white square is displayed in front of input and output.
When routing is already done, a black cross is displayed.
When routing is not available due to hierarchy constraints, a grey square is displayed.
Note that all grids can be grayed if hierarchy is not known, or not yet detected.
Actions available are:
• Routing: It is simply done by left clicking in the grid while highlighting desired
input and output.
• Un-routing: Left clicking on a square where black cross is displayed will un-route
output from input.
• Direct ES Channel assignment: Left click on summary icons allows user to directly
set ES Channel to an input or output.
• Expand/Collapse: To simplify viewing, left-click on “-“ button near device name, or
directly on device name if too short, will collapse all inputs or outputs from device.
To see full device inputs or outputs, just left click on device name to expand it
again. When collapsed, routing is not available for device but a summary is
displayed to see if routing is done on device.
• Setting a new alias for a device, or an input/output: It is done by right-clicking on
the correct row or line. A window will appear to set new alias.
AVS-ESMonitor – User’s Manual AuviTran 26