User guide

Operation Mode
Operator's Handbook, AutroSafe Interactive Fire Alarm System, Release 3, ASAFE-FB/FE Rev. A, 010531,
Autronica Fire and Security AS
Page 10
3. Operation Mode
3.1 Introduction
The Repeater Panel operates in Operation Mode, and will
automatically enter this mode after startup
The display may look as follows in the panel’s idle state.
AUTROSAFE
SelfVerify
19:23
Total: 3
Figure 3-1: The idle display
3.2 Conditions in Operation Mode
In Operation Mode, the system can be in quiescent condition (lowest
priority), or in one or any combination of several conditions. The table
below shows the different conditions, and if / how the conditions are
indicated on the Repeater Panel.
Conditions Indication
on display
Indicators that are lit
(see also chapter 2.2)
fire alarm condition
(highest priority)
Yes. ALARM indicator and
Fire Brig. Signalled indicator.
More Events indicator if more
than one fire alarm.
fault warning
condition
No indication. Fault indicator.
disablement
condition
No indication. Function Disabled indicator.
Included in
disablement:
Immediate actioning
disabled condition
No indication Function Delayed indicator and
Function Disabled indicator
fire warning condition
(including prealarm)
No indication. No indicators are lit -
no indication.
test condition No indication. No indicators are lit -
no indication.
Note that only fire alarms are indicated on the Repeater Panel's
display.