User guide

Table of Contents
Commissioning Handbook, AutroSafe Interactive Fire Alarm System, Release 3, P-ASAFE/EE Rev. E, 2005-02-16,
Autronica Fire and Security AS
Page 1
Table of Contents
1. Introduction.......................................................................4
1.1 About the Handbook ......................................................................... 4
1.2 The Reader ....................................................................................... 4
1.3 Reference Documentation ................................................................ 4
2. Verifying the Loops ..........................................................5
2.1 AS-2000 Loop Diagnostic Tool .........................................................5
2.2 Verification Procedure....................................................................... 5
3. Consistency Check of Configuration Data .....................6
3.1 Introduction........................................................................................ 6
3.2 Parameters Used for the Consistency Check ................................... 6
3.3 Importing Loop Data from the AS-2000 Tool .................................... 7
3.4 Consistency Check Using the AS-2000 / Config Mismatch Tool...... 7
3.5 Generating Configuration Files ......................................................... 7
4. Commissioning Procedure ..............................................8
4.1 Verifying the System Before Startup ................................................. 9
4.1.1 Recommended Equipment .....................................................9
4.1.2 Before You Begin .................................................................... 10
4.1.3 Required Strapping for System Units with Optional
Printer......................................................................................
11
4.1.4 Verifying the AUTROLON Flash Memory on all System
Units ........................................................................................
11
4.1.5 Verifying Connections on the Operator Panel / Repeater
Panel and Information Panel...................................................
12
4.1.6 Verification Procedure for Fire Alarm Control Panel /
Controller.................................................................................
15
4.2 Addressing the System Units ............................................................ 16
4.2.1 General ...................................................................................16
4.2.2 Addressing System ID on All System Units (except for
Controllers)..............................................................................
16
4.2.3 Addressing System ID on Controllers..................................... 17
4.2.4 Addressing Ring ID on the Fire Alarm Control Panel
(Booting Panel) .......................................................................
17
4.2.5 Number Series - System ID and Ring ID ................................ 18
4.2.6 Examples of Addressing ......................................................... 19
4.2.7 Jumper Settings on the LON Interface Board......................... 20
4.3 Startup Procedure .............................................................................21
4.3.1 Preparing the Fire Alarm Control Panel / Controller ............... 21
4.3.2 Entering Programming Mode .................................................. 22
4.3.3 Configuration Files .................................................................. 23
4.3.4 Communication Setup............................................................. 24
4.3.5 Locating Configuration Files ................................................... 24
4.3.6 Downloading Configuration Files ............................................ 25
4.3.7 Booting the System from the Fire Alarm Control Panel
BS-320 (Booting Panel) ..........................................................
26