User guide

Commissioning Handbook, AutroSafe Interactive Fire Alarm System, Release 3, P-ASAFE/EE Rev. E, 2005-02-16,
Autronica Fire and Security AS
Page 22
4.3.2 Entering Programming Mode
When the necessary preparations are made, you can enter
programming mode.
This is done by pressing the reset button on the Display Board
BSR-310. As the Controller is not equipped with the Display Board,
reset is performed by pressing the reset button on the Processor
Board EAC-300.
• Press the Reset button (S5 on BSR-310, X1 on EAC-300)
Observe the four uppermost
indicators on the left hand side of the
Fire Alarm Control Panel (Fault,
Function Disabled, Function Delayed,
Fire Brig. Signalled).
These indicators will turn on (yellow
light), indicating that the system has
entered programming mode.
(The green Power indicator will go
off).
Power
Fire Brig.
Function
Function
0
ALARM
i
C
98
7
6
5
4
3
2
1
Mute
Silence
Rese
More
Testing
Fire Brig.
System
Alarms
Fire Brig.
Fault

®®
Alarms
Applies
to
BS-310
BS-320
BS-330
BV-320
BU-320