User guide

Commissioning Handbook, AutroSafe Interactive Fire Alarm System, Release 3, P-ASAFE/EE Rev. E, 2005-02-16,
Autronica Fire and Security AS
Page 20
4.2.7 Jumper Settings on the LON Interface Board
The Fire Alarm Control Panel and the Controller are both provided
with the necessary LON Interface Board (EAU-310). The board must
have the correct jumper settings (factory set).
This is done by setting jumpers in the correct positions on the
connector located at the right bottom side of the LON Interface Board
(see drawing below).
The LON Interface Board is shown as it is mounted onto the
Processor Board EAC-300 in the Fire Alarm Control Panel or
Controller.
• Counting from left to right, the jumpers must be placed on
connectors 4, 6 and 7, when viewing the board inside the system
unit.
EAU-310