User guide

Show Status
Operator's Handbook, AutroSafe Interactive Fire Alarm System, Release 3, ASAFE-FO/FE Rev. I, 2009-02-27,
Autronica Fire and Security AS
Page 58
10.6 Show Status - Disablements
This menu gives detailed information on the current status of the
disablements in the system. It provides detailed information on the
disablement of the following:
• Detection Zones
• Points (fire detectors, manual call points)
• Fire Alarm Devices (FAD)
• Fire Alarm Routing Equipment (FARE)
• Outputs (FPE)
• Fault Warning Routing Equipment (FWRE)
• Immediate Output Actioning
• All
Step Actions to be taken Display Indication
1
To enter the Main Menu, press

MENU
19:23
Total: 3
1 SHOW STATUS
2 DISABLE
3 ENABLE
4 SYSTEM
5 SERVICE
2
To select SHOW STATUS, press 1.
SHOW STATUS
1 FIRE ALARMS
2 FIRE WARNINGS
3 FAULTS
4 DISABLEMENTS
5 DETECTION ZONES IN TEST
6 ACTIVATED OUTPUTS
19:23
3
To select DISABLEMENTS, press 4.
SHOW STATUS
DISABLEMENTS
1 DETECTION ZONES
2 POINTS
3 FIRE ALARM DEVICES
4 FIRE ALARM ROUTING EQUIPMENT
5 OUTPUTS
6 FAULT WARNING ROUTING EQUIPMENT
7 IMMEDIATE OUTPUT ACTIONING
8 ALL
19:23
SHOW STATUS
DISABLEMENTS
1 DETECTION ZONES
2 POINTS
3 FIRE ALARM DEVICES
4 FIRE ALARM ROUTING EQUIPMENT
5 OUTPUTS
6 FAULT WARNING ROUTING EQUIPMENT
7 IMMEDIATE OUTPUT ACTIONING
8 ALL
19:23
The 3 steps above will lead you to Show Status - Disablements, where you can continue viewing the
status of the disablements (1-8), shown on the following page (step 4).