User guide

Error! Style not defined.
Error! Unknown switch argument., AutroSafe Interactive Fire Alarm System, Release 3, P-ASAFE-LV/FE, Rev. A, 033105,
Autronica Fire and Security AS
Page 7
3.3 Installing the Hardware
3.3.1 Overview
The LoopViewer can be run when connected to an AutroSafe
operating panel (Fire Alarm Control Panel BS-310/320, BC-320), or
standalone connected to the loop with an external interface unit.
One of the serial ports on the computer must be connected to the
Communication Module (BSL-310) in the operating panel or to an
external interface unit (both alternatives are shown below).
The external Interface Unit WAS-2000 consists of 1 Power Module
BSS-310, 1 Communication Module BSL-310, and 1 Loop Driver
Module BSD-310 (batteries and charger unit also included). These
modules are always included in an operating panel.
If connection to the loop is through the WAS-2000 it will be the only
loop available. If connection is through a panel, the loop driver
modules BSD-310 / BSD-311 may be selected from the LoopViewer
program. Default selection will be to the first loop driver module.
For detailed information on cable connections, consult the following
chapters.
Loop Driver Module in Fire Alarm
Control Panel BS-310/320
PRESS HERETRYKK HER
KNUS GLASSET
BREAK GLASS
Detector
I/O Unit
Manual Call Point
BN- 320
BRANNALARM
Tilpasningsenhet
FIRE ALARM
Interface unit
Nr.
No.
BN- 320
BRANNALARM
Tilpasningsenhet
FIRE ALARM
Interface unit
Nr.
No.
220V AC
WAS-2000
Power
Fire Brigade Msg
Fire Vent Activated
Fire Ext Activated
0
ALARM
?
C
98
7
6
5
4
3
21
Silence Buzzer
Silence Sounders
Reset
More Alarms
Prewarning
Early Warning
System Fault
Function Disabled
Test
Fault
Self Verify
General Alarm
PRESS HERETRYKK HER
KNUS GLASSET
BREAK GLASS
Detector
I/O Unit
Manual Call Point
BN- 320
BRANNALARM
Tilpasningsenhet
FIRE ALARM
Interface unit
Nr.
No.
BN- 320
BRANNALARM
Tilpasningsenhet
FIRE ALARM
Interface unit
Nr.
No.