User guide

Error! Style not defined.
Error! Unknown switch argument., AutroSafe Interactive Fire Alarm System, Release 3, P-ASAFE-LV/FE, Rev. A, 033105,
Autronica Fire and Security AS
Page 11
4. Operating the Tool
4.1 Overview
The LoopViewer starts by asking you for the COM-port to which the
XJA-027 cable has been connected.
Select the COM-port and then the OK button.
The LoopViewer will then check for a correct connection to a BSL-310
in a WAS-2000 or inside a panel and show this window for a few
seconds:
Then the LoopViewer will automatically open the Topology window as
shown below.
If you do not see this AutroSafe logo you probably do not have a
correct connection from your computer to the BSL-310
Communication Module. If the XJA-027 cable seems to be OK, you
also have to check that the COM-port selected is the one where the
XJA-027 cable is physically connected. One other possibility is that
the WAS-2000 or the panel has not been powered up.