User guide

Error! Style not defined.
Error! Unknown switch argument., AutroSafe Interactive Fire Alarm System, Release 3, P-ASAFE-LV/FE, Rev. A, 033105,
Autronica Fire and Security AS
Page 10
3.3.4 Cable Connections to an AutroSafe Operating Panel
If the LoopViewer is to be connected to the Communication Module
BSL-310 inside an operating panel, a flat ribbon cable XJA-027 must
be used.(Available from Autronica Fire and Security AS.) A 9-pin Dsub
connector for the COM-port on your computer, and a ribbon cable
connector for the panel. The ribbon cable that is already connected to
the Communication Module BSL-310 inside the panel, must be
disconnected (see figure) before the other end of the cable from the
computer can be connected.
Note:
To avoid activating the internal buzzer when disconnecting the ribbon
cable from the Communication Module BSL-310, turn the power OFF
before disconnecting the ribbon cable. When you have connected the
external ribbon cable from the computer, turn the power ON.
All power connections to the Power Module BSS-310 are already
done. The Loop Driver Modules BSD-310 / BSD-311 are already
connected to the loops.
3.4 Starting LoopViewer
• Start the LoopViewer by double clicking at the shortcut you made
in chapter 3.2
You will be asked which serial port to use (COM1 to COM4), and then
the software is running.