User guide

Error! Style not defined.
Error! Unknown switch argument., AutroSafe Interactive Fire Alarm System, Release 3, P-ASAFE-LV/FE, Rev. A, 033105,
Autronica Fire and Security AS
Page 8
3.3.2 Cable Connections Overview in Interface Unit WAS-2000
Consult the drawing below, and do the following:
• Available with the WAS-2000 there is a ribbon cable XJA-027 with
a 9-pin Dsub and a ribbon cable connector.
• Connect the 9-pin Dsub connector to one of the serial ports (COM1
or COM4) on your computer and the flat ribbon connector to the
BSL-310 communication module in the WAS-2000.
• Connect the WAS-2000 Interface unit to the 220V AC mains outlet.
Note:
If a battery is installed, it must be disconnected when not in use, to
avoid discharge.
24V DC Out
In
1
2
4
5
6
3
+
-
+
-
Detector
3
1
2
3
2
1
3
1
2
BSD-310
+ Ø
+ Ø
- Ø
- Ø
Cable
to PC
Com-
port
**
24VDC
POWER
SUPPLY
(fuse inside)
Ø
Ø
Ø
Ø
Ø
Ø
24VDC
BSS-310 BSL-310 BSD-310 / BSD-311
Al_Com
+
- out
Detector loop
+
- in
Mains 220VAC
+ 24 V -
BATTERY
(*optional)