User guide

Installing I/O Modules

Installation Handbook, AutroSafe Interactive Fire Alarm System, Release 3, 116-P-ASAFE-FA/DE,

Rev. J, 2011-12-06,

Autronica Fire and Security AS

3.3.3 Removing

 Unplug the connection block.

 Use a screwdriver to carefully

lift the topmost module upwards

(1) until the connector between the

modules is free.

 Use the screwdriver to slightly

bend the left side of the

fastener towards left (2) until

it loosens, then remove (3) the

module.

 If necessary, continue removing

the next one in the same way.

3.3.4 Before Connecting Cables

 Before connecting cables, make sure that the mains power is not

connected.

 Remove the fuses F1 and F2 on the Power Supply (refer to

illustration in chapter 3.3.1). Do not replace the fuses until

commissioning of the system.

POWER OFF!

3.4 Data Sheets - I/O Modules

The AutroSafe User Documentation provides data sheets for I/O

modules, including a short description of the I/O module, its

application, plus technical specifications and cabling. The subsequent

chapters in this handbook provide necessary information on

connections, screw terminals and signals.

 Power Module, BSS-310

 Communication Module, BSL-310

 Loop Driver Module, BSD-310 / BSD-311

 Output Module, monitored, BSB-310

 Output Module, BSJ-310

 Input Module, monitored, BSE-310

 Input Module, BSE-320