User guide

Mounting
Installation Handbook, AutroSafe Interactive Fire Alarm System, Release 3, 116-P-ASAFE-FA/DE,
Rev. J, 2011-12-06,
Autronica Fire and Security AS
1.11.5 Mounting the Batteries
 Unscrew the screw as shown on the illustration below.
 Lift the lower part of the cover off the bottom slot and remove the
battery cover.
 Place the batteries in their position as shown, then reassemble the
battery cover.
1.11.6 Reassembling the Front Panel
 When all the necessary cable connections are done, reassemble
the front panel.
 Open the front panel.
 Tighten the 4 wing nuts on the right and left side inside the cabinet.
 Interconnect the ribbon cable(s) between the front panel and the
cabinet.
 Close the front panel, and tighten the two lock screws on the top
and the bottom on the right hand side.
Battery Cover
Screw
Batteries;
2x12V / 12Ah