Specifications

Cable Connections
Installation Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME-INSTALL/DGB Rev. E, 2011-08-16,
Autronica Fire and Security AS
Page 39
9.11 Connections to Mimic Drivers (BUR-200)
The BUR-200 is a Mimic Driver that is capable of driving 32 LEDs with
series resistors on a mimic panel for additional indication of alarms. In
addition, 8 standard monitored inputs can be used for reading various
switches.
Power redundancy is achieved by using a daisy-chain connection with
master and slave drivers. A maximum of 8 Mimic Drivers can be
connected to the panel bus, providing a total of 256 outputs and 64
monitored inputs.
Note that when connecting additional panels on a panel bus, the
communication cables inside the cabinet (Fire Alarm Control Panel)
must be connected as shown in chapter 9.8.2.
CAUTION
Do not connect the 24V wire to the terminal points used for
communication (A and B terminals). This will lead to
malfunction of the communication circuits.
!
NOTE: For specific information
on the installation and cable
connections for maritime
installations, refer to chapter
10.