Specifications

Addressing Panels
Installation Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME-INSTALL/DGB Rev. E, 2011-08-16,
Autronica Fire and Security AS
Page 13
6. Addressing Panels
6.1 Rotary Switch on Panels
All Autroprime panels (BS-200, BS-200M, BS-200L, BS-211, BU-210,
BV-210) must be assigned addresses by means of the rotary switch
located on the rear side of the panel. The addresses must be set
before mounting.
6.2 Addressing the Fire Alarm Control Panel (BS-200)
The main Fire Alarm Control Panel (BS-200, BS-200L, BS-200M)
must always have address 0 (the arrow pointing straight downwards).
Address 0 is preset from the factory.
6.3 Addressing other Panels
All other panels connected to the RS-485 Panel Bus, including
Repeater Panel BS-211, Fire Brigade Panel BU-210, Information
Panel BV-210 and “Larmlagringspanel BU-211” have addresses from
1-9.
6.4 Addressing Mimic Drivers
To address the Mimic Drivers the X2 Panel Bus Address Switch is
used. If S2.7 is set to Master, X2 sets the panel bus address. If S2.7 is
set as slave, X2 sets the RS-485 daisy-chain slave address. The
range for the switch is 1-9.
Mimic Driver B