User guide

Operating the Tool
User Guide AutroClient, Autroprime Interactive Fire Detection System, 116-P-APRIME2-AUTCLI/LGB, 2012-06-15,
Autronica Fire and Security AS
Page 9
4. Operating the Tool
4.1 Overview
The AutroClient has several windows/entries for configuration and for
monitoring Autroprime panel states. The configuration views will be
the same in off-line (when a Config.xml file is loaded) and on-line
(connected to an Autroprime panel) modes.
The AutroClient has three operation modes (access levels), the
Monitoring mode (read only), the Control mode (send operating
commands) and the Configuration mode (configure system unit
relations), of which the two latter are protected by passwords.
4.2 Monitoring mode
The AutroClient monitoring mode is the read only mode and the
default mode of the AutroClient. The system topology will be
presented in the Site view, which displays each unit’s property, but the
properties can not be changed.
In off-line mode (loading a Config.xml file) only the Site view will be
present.
In the online mode (AutroClient connected to an Autroprime panel) the
Site view and the status views will be present. The status views are
the Alarm, Fault, Disable, Activate, Supervisory and Test view.



Figure 5. AutroClient in Monitoring mode.