User guide

Operating the Tool
User Guide AutroClient, Autroprime Interactive Fire Detection System, 116-P-APRIME2-AUTCLI/LGB, 2012-06-15,
Autronica Fire and Security AS
Page 16
4.4.3 Configuring Alarm Zones
 To configure the Alarm Zones, select the AutroClient toolbar AZ
button and the Alarm Zones view is displayed. For a default
configuration all the Fire Alarm Devices are connected to the
Default Alarm Zone.
 To add a new Alarm Zone, first select an Alarm Zone in the tree
view (left side view) which should be the Parent Alarm Zone and
type a name. The new Alarm Zone will be connected to the
selected Alarm Zone shown in the tree control.
Figure 15. AutroClient Alarm Zone view.
 To move Fire Alarm Devices to the new Alarm Zone, use drag and
drop in the tree view. Select the Fire Alarm Devices and drag them
from the Default Alarm Zone or another zone and drop them into
the new Alarm Zone.
 To change the Alarm Zone name, double click the name and edit.
4.4.4 Configuring Activation Groups
 To configure the cause/effect properties, select the AutroClient
toolbar CauseEffect button and the cause/effect view will be
displayed.
Note that all responses/actions (“CauseEffect“) executed by the
Autroprime panel, based on events from units, are in terms of
“activation group“
Figure 16. AutroClient cause/effect view.