User guide

Operating the Tool
User Guide AutroClient, Autroprime Interactive Fire Detection System, 116-P-APRIME2-AUTCLI/LGB, 2012-06-15,
Autronica Fire and Security AS
Page 13
4.4 Configuration mode
The AutroClient configuration mode is used when the AutroClient is
connected to an Autroprime panel or in off-line mode when the
configuration is loaded from Config.xml.
In configuration mode the user can;
 rename units
 add and delete Detection Zones and Alarm Zones
 move points (detectors) to other Detection Zones
 move Fire Alarm Devices to other Alarm Zones
 add, delete or modify activation groups.
 modify System settings data (not yet available)
 To set the AutroClient in configuration mode, select the ComboBox
Configuration option in the AutroClient toolbar as shown in figure
10.
 Type the password “9999”
Figure 10. Set the AutroClient in Configuration mode.