User guide

Operating the Tool
User Guide AutroClient, Autroprime Interactive Fire Detection System, 116-P-APRIME2-AUTCLI/LGB, 2012-06-15,
Autronica Fire and Security AS
Page 10
4.3 Control mode
The AutroClient control mode is used when the AutroClient is
connected to an Autroprime panel. In the control mode the user can
execute panel operations like Reset, Silence, Ack faults, disable units,
set units in test etc.
 To enter control mode, select the ComboBox Control option from
the AutroClient toolbar as shown in figure 6.
 Type the password “1234”


Figure 6. Set the AutroClient in Control mode.
4.3.1 User panel commands
 To use the User panel commands like Reset, Silence etc. from the
AutroClient, open a connection to an Autroprime panel and set the
AutroClient in Control mode.
 Select the Sites in the tree control and select the Autroprime
operator panel. The user panel command buttons will be displayed.
Figure 7. AutroClient user panel commands.