Datasheet

Write Protect
Addendum, AutroFlame X33AF 116-P-X33AFADDENDUM/YGB, DEC P/N 95-8624, 2007-11-12, Autronica Fire and Security AS
Page 24
22. Write Protect
This function enables the operator to enable/disable password and
write protection capability, as well as to enter or change a password.
The device is provided from the factory with Write Protect off. With
Write Protect on, the use of a password is required to enable writing to
the device.
1) Set Password The password is used to validate the command to
enable or disable writes in the device. (The factory default password
is: 1*******. Once the password has been changed, the default
password is no longer valid.)
CAUTION
Always record the new password. If the password is forgotten, the
device must be returned to the factory for re-programming.
2) Set Write Protect With Write Protect “On”, variables cannot be
written to the device and commands that cause actions to be
performed in the device cannot occur.
3) Write Protect (Y/N) This indicates whether or not Write Protect is
enabled.