Specifications

Installation
Interfacing BU70 Display Units and BU100/BU101 Panels, AutroSafe Interactive Fire-Alarm System,
116-P-BSL337/EE, Rev. D, 2007-01-25,
Autronica Fire and Security AS
Page 10
3. Installation
3.1 Hardware Requirements
In order to interface BU-panels to an AutroSafe system, the following
hardware is required:
• AutroSafe Serial Communication Board EAU-321 — port 1 or 2
(See section
3.7 and 3.8).
• AutroSafe BU-70 Interface BSL-337
• Current Loop/RS-232 Converter, BSL-12/2
• Cables: XBA-055 or XGK-1/20-30 with terminal block
• If more than 16 BU-panels are to be connected, additional
BSL-337 interfaces and Current Loop/RS-232 Converters
BSL-12/2 must be installed (refer to chapter
3.4).
3.2 Software Requirements
• AutroSafe system software version 3.2.0 or later
• AutroSafe AutroCom parameters:
- baud rate 9600
- 8 data bit
- none parity
- 1 stop bit