Owner`s manual

20
initialize the system and register all of the FOBs.
Troubleshooting
The AUTOTETHER
TM
system is designed to be maintained by factory
trained representatives. The system has extensive self-test
capabilities.
o The system will alert you when the batteries require changing.
WARNING
NEVER use partially discharged batteries.
NEVER mix partially discharged batteries with new batteries
Two AUTOTETHER
TM
systems operating close to each other on the
same communication channel can cause erratic behavior. See the
FOB Dipswitch #4 section of this manual to resolve this problem.
If the YELLOW gasket installed on each FOB and the Host becomes
damaged, please contact us for a replacement.
For all other issues, please call us Toll Free at [phone]
The FCC Wants You To Know
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications to this product not expressly approved by
Autotether, Inc., or operation of this product in any way other than as
detailed by the owner’s manual, could void your authority to operate this
product.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause