Owner`s manual

 If the Host is not found within 3 minutes, the FOB will

automatically turn off to conserve battery power

 The FOB communicates with the Host every 0.5 seconds

o If the Fob is turned on and the ON/OFF switch is held for more

than 2 seconds, the unit goes into an alarm mode. An alarm

trips the actuator, audible alarm and flashing LEDs

 LED will go steady RED

NOTE

You cannot turn off the FOB with the power button on the FOB. The

FOBs will automatically go off 3 minutes after no communication with the

HOST.

FOB LED

o FOB OFF – LED OFF

o FOB ON, Unregistered – LED steady GREEN

o FOB ON, low batteries – LED flashing AMBER each 2 sec

o FOB ON, batteries bad – LED steady RED

o FOB ON, Registered – LED Flashing GREEN each 4 sec

 If a registered FOB goes out of range or the signal to the

Host is interrupted, the LED will change to Steady GREEN

until the FOB is re-registered with the Host

 If no Host is found after 3 minutes, FOB will turn itself OFF

FOBs and Settings

The AUTOTETHER

Host can monitor a maximum of four (4) FOBs

simultaneously. The Host and FOBs come channelized and pre-set from

the factory for normal operation. Once the AUTOTETHER

system is

properly installed and activated, the FOBs and Host communicate with

each other every 0.5 seconds. If that communication is interrupted, the

alarm mode sounds and for the operator (yellow) FOB the kill switch

actuator is triggered to stop the vessel’s engine(s).

For proper AUTOTETHER

operation and to prevent false alarms and

inadvertent engine shutdown, it is critical that the FOBs be worn

correctly by the vessel’s operator and the passengers.

The FOB should be worn so that it has uninterrupted communication

with the host