User Guide

REM Operations Toolbar
Related ProcedureCommand-Line
Command
Toolbar
Icon
Smoothing REM Linework (page 194)ismooth
Trimming and Extending REM Lines (page
191)
itrim
Trimming and Extending REM Lines (page
191)
iextend
Filleting REM Lines (page 192)ifillet
Offsetting REM Objects (page 193)ioffset
The Quick Bar
The Raster Design Quick Bar provides quick access to the settings you use most
often while performing REM or VTools operations. This toolbar is only available
when using the Map Classic Workspace.
The following settings can be toggled on and off on the Quick Bar:
DescriptionNameToolbar
Icon
Enables raster snap which allows you to
snap to raster objects.
Raster Snap
Snaps to the center of a raster line. The
entire width of the line must be in the
snap window.
Raster Snap Center
Snaps to the end of a raster line.Raster Snap End
Note When a line ends because it inter-
sects with another line, this is considered
an intersection, not an end point.
298 | Appendix A Troubleshooting and Reference Guide