User Guide

■ End snaps to the end of a raster line.
NOTE When a line ends because it intersects another line, this is considered an
intersection, not an end point.
■ Corner snaps to the intersection of 2 raster lines.
■ Intersection snaps to the intersection of 3 or more raster lines. The entire
intersection must be in the snap window.
■ Edge snaps to the edge of a raster line. Any part of the raster line can be
in the snap window.
NOTE Raster Snap is active only when you are in a command and are being
prompted for a point.
Snap Modes | 239