Operating instructions

10
Follow this procedure to set the Programming
Features to factory default settings.
1. Enter Start Feature or Convenience
Feature program mode.
2. After entering programming mode, press
Transmitter Button 4.
• The LED will flash 4 times indicating the
reset signal was received.
• All Programming options are now set to
factory default settings.
3. Turn ignition off.
Remote Start Programmable Features
1. Engine Start Sense. Selects between Tach
Start for actual RPM monitored starting or
Smart Start for tachless operation. Smart Start
Ext extends the starter crank time to 1.8
seconds.
2. Ignition 2 Relay Programing. Selects
between Ignition 2, Starter 2, or Accessory 2
output timing for this relay. In accessory 2
mode the output will not turn on until after
engine cranking.
3. Transmission Type. Selects between
automatic transmission and manual transmission
types. On manual transmission vehicles, the
remote start feature will not operate unless the
proper vehicle exit sequence is performed.This
operating mode protects against in-gear
starting but is not completely without risk.
Installation and safe use of the remote start
feature on a manual transmission vehicle is the
sole risk of the vehicle’s owner, and the
manufacturer assumes no liability for use in
manual transmission vehicles.
Manual Transmission Mode Exit Sequence: With
engine running, press unlock button. Turn
ignition off (engine will stay running) and exit
vehicle. When all doors are closed, press lock
button to turn off engine and lock doors. The
system will be able to remote start as long as
the doors have not been unlocked prior to
remote starting.
4. Engine Type. Selects between gasoline and
diesel engine types. There are two operation
choices for diesel engine equipped vehicles, 10-
second timer mode for vehicles without a glow
plug wire and glow plug monitor mode for
vehicles with a wait-to-start indicator light.
10-Second Timer Mode: For diesel engines where
a proper glow plug wire cannot be located, set
the Engine Type to button 2 setting which
automatically cranks the starter after a 10-
second warm up period for the glow plugs.
Glow Plug Monitor Mode: For vehicles with a
wait-to-start indicator, connect to the proper
vehicle wire and set Engine Type to button 3
setting which automatically cranks the starter
REMOTE START PROGRAMMABLE FEATURES
Step Function
Button 1 Button 2 Button 3 Button 4
1. Engine Sense Tach/RPM Smart Sense Smart Sense Ext
2. Ignition 2 Relay Ignition 2 Starter 2 Accessory 2
3. Transmission Type Automatic Manual
4. Engine Type Gasoline Diesel Timer Diesel Glow Plug
5. Engine Run Time 10 minutes 15 minutes 20 minutes 30 minutes
6. Cold Start Timer 1 hour 2 hours 4 hours 12 hours
7. Turbo Timer Mode Off I minute 3 minutes 6 minutes
8. Black/Red Wire Program Ground w/Run Factory Disarm Defroster pulse Defroster latch
9. Remote Start Input 1 Pulse 2 Pulses 3 Pulses
10. Tach Locator Feature Off On
S series.qxd 9/24/2004 11:08 AM Page 10