User guide

User guide P.9
Ignition Valet: This feature allows you to set Valet Mode using the ignition key.
Remote valet: This feature allows you to set Valet Mode using the transmitter.
Valet switch: This feature allows you to set Valet Mode using a push button switch (optional).
To put the system into Valet Mode
Using the KEY (Ignition Valet Mode):
1. Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the
IGNITION/RUN and OFF positions 5 times until the parking lights flash 3 times.
2. Turn the ignition OFF.
3. The LED on the antenna will stay ON indicating that the vehicle has successfully entered
Valet mode.
4. The icon will appear on the LCD display.
Using the TRANSMITTER (Remote Valet Mode):
1. Press the and buttons simultaneously until the icon appears on the LCD display.
2. The LED on the antenna will stay ON indicating that the vehicle has successfully entered
Valet mode.
Using the PUSH-BUTTON SWITCH (Valet Switch Mode):
1. Insert the ignition key into the ignition switch.
2. Turn the key to the ON position
3. Within 5 seconds, press the push-button switch until the parking lights flash 3 times.
4. Release the push-button and turn the ignition to the OFF position.
5. The LED on the antenna will stay ON indicating that the vehicle has successfully entered
Valet mode.
6. The icon will appear on the LCD display.
To take the system out of Valet Mode
Using the KEY (Ignition Valet Mode):
1. Insert the ignition key into the ignition switch. Within 10 sec., cycle the ignition key to the
IGNITION/RUN and OFF positions 5 times until the parking lights flash twice.
2. Turn the ignition OFF.
3. The LED on the antenna will switch OFF indicating that the vehicle is now out of Valet mode.
4. The icon will disappear from the LCD display.
Using the TRANSMITTER (Remote Valet Mode):
1. Press the and buttons simultaneously until the icon disappears from the LCD
display.
2. The LED on the antenna will switch OFF indicating that the vehicle is now out of Valet mode.
Using the PUSH BUTTON SWITCH (Valet Switch Mode):
1. Insert the ignition key into the ignition switch.
2. Turn the key to the ON position.
3. Press the push-button switch until the Parking lights flash twice.
4. Release the push-button and turn the ignition to the OFF position.
5. The LED on the antenna will switch OFF indicating that the vehicle is now out of Valet mode.
6. The icon will disappear on the LCD display.
If someone attempted to remote-start the vehicle while in Valet Mode; the parking lights will turn
ON, then OFF, then will flash twice.