User guide
User guide P.11
Example: If your remote car starter is programmed for a run time of 3 minutes and your vehicle
has been running for 2 minutes already, pressing the button will reset the counter to zero and
allow the engine to run for another cycle (in this case, 3 minutes).
IntrusionCodesviaLEDlight
The system monitors the following:
• Any vibrations sensed by the shock sensor such as someone breaking of the window,
windshield, etc.
• Doors
• Ignition
• Trunk
• Hood
Note: If an intrusion has occurred the siren will sound for a maximum of 1minute.
When an intrusion has occurred, pressing unlock will make the siren chirps four times. The
antenna’s LED will provide an intrusion code corresponding to the type of the intrusion that
occurred. The LED intrusion codes are flashed in continuous loops.
2x = Doors intrusion 5x = Panic
3x = Shock Sense 6x = Ignition
4x = Hood 7x = Trunk
CarFinder
When enabled, the Car Finder option will help you locate your vehicle by sending a pulsating signal
through the siren. The siren will chirp once each time the and are pressed simultaneously.
TemporaryChirpDelete
To temporarily disable the chirp confirmations of the siren upon arming and disarming (e.g. in a
quiet neighbourhood):
• Press the button. The remote will beep once.
• Within 3 sec., press the or
button to arm or disarm system without any chirp.
MissingaStartoraStopConfirmation
If you have not received a Start or the Stop confirmation after pressing the button, pressing the
button within range of the remote starter’s signal will refresh the display and will confirm if the
vehicle was started or stopped.
If no Start Confirmation Was Received:
• Press the button:
¾ The remote’s icon will start flashing
¾ The icon and runtime time countdown will be displayed.
If no Stop Confirmation Was Received:
• Press the button:
¾ The will be displayed
¾ The remote’s icon and the runtime countdown will disappear.