Installation guide

P. 16 Installation Guide CT-3400 TW
4. Press the TRUNK button to lock the doors and shut down the engine after 60 sec. running in
Turbo Mode.
Cold Weather Mode
If Cold Weather Mode is activated, it will start and run the engine for 3 minutes every 2 hours (8 or
20 minutes for diesel engines). This will go on for a period of 24 hours.
To activate Cold Weather Mode:
Press F then START/STOP button for three seconds. The parking lights will flash 3 times. There will
be one (1) “BEEP” as a confirmation. The icon will be displayed.
To exit Cold Weather Mode, do any of the following:
a) Open the hood.
b) Start the engine by remote.
c) Turn the ignition key to the IGNITION ON (RUN) position.
d) Place the vehicle into valet mode.
e) Press F then START/STOP buttons for 3 seconds.
To exit Cold Weather in Safe Start Mode:
Press F then START/STOP buttons for 3 second, the parking lights will flash once. The icon will
disappear.
Use Mode 2, Function 4, Option 1 to set a diesel engine to a 20-minute run time in Cold Weather
Mode. Option 3 will otherwise set a diesel engine to a 8-minute run time.
Ignition-controlled Door Locks
ON by default (if remote door locks are installed). This feature will LOCK all doors when the brake
pedal is pressed while the ignition key is in the
IGNITION ON (RUN) position. The unit will UNLOCK all
doors when the ignition key is turned to the
OFF position.
• If the Ignition Lock Only Option is selected, the system will only lock the doors.
• Ignition Unlock Only is selected; the system will only unlock the doors (provided the
ignition key was in the
IGNITION ON (RUN) position and that the brake pedal was pressed
at least once).
Smart Rearm
The system will be rearmed only once. Extra rearm pulses will not be sent when LOCK is pressed
several times. (Certain factory alarms are affected when additional rearm pulses are sent once the
system is armed.)
Secure Lock
This feature allows the module to control certain OEM factory alarm systems without requiring the
use of other wires for disarming the OEM alarm. (Namely, this feature is designed for OEM
systems that use the factory lock wire to arm the alarm and the unlock wire to disarm it.)
Standard Secure Lock
If this Option is selected, upon receiving a remote START signal, secure lock will UNLOCK the doors
(disarming the factory Alarm); 1/2 sec. after remote start it will re-lock the doors. 4 seconds after
shutdown, secure lock will re-lock all doors (arming the system once again). Please note that
most OEM systems will not rearm the alarm while the engine is running, but will lock the doors.