Installation manual

The Tach Start feature requires connection to
the vehicle’s tachometer wire, or an injector (-)
wire if the tach wire is not available. The Tach
Start feature provides reliable operation with
virtually any vehicle and in severe temperature
extremes. When Tach Start is selected, the vehi-
cle’s tach signal must be “learned” through sys-
tem programming. (see below)
To Program the Tach Start feature:
1. Enter System Programming. (see Entering
Programming)
2. Program Step #14 to Tach Start using trans-
mitter button 2.
3. Re-enter system programming, and go to
Step #15.
4. Immediately start the vehicle with the key to
avoid the programming sequence timing out.
5. Press transmitter button 1 to learn the vehi-
cle’s tach signal.
• The LED will flash once if the tach was
learned.
• The LED will flash 5 times if the tach was
not learned.
6. Turn off ignition to save settings.
The default setting for the engine mode is Gas
Engine. For diesel vehicles, the engine type for
Step #15 must be set to Diesel Engine. When
programmed for diesel engines, the BLUE/YEL-
LOW wire (glow plug input) is monitored to
make sure the glow plugs have warmed up
before the engine begins cranking. If the glow
plug wire is not connected, the unit has a built-
in timer that waits 15 seconds before cranking
the starter.
5
Programmable Features
Step Function Button 1 Button 2 Button 3
1. Ignition Locking On Off
2. Ignition Unlocking All Doors Driver only Off
3. Door Unlock Pulse Single Double
4. Door Lock Pulse Width 1 second 3 seconds
5. Auxiliary 2 Auto Activate on Lock Off On
6. Auxiliary 1 Output Momentary 10 seconds Timed Latched
7. Auxiliary 2 Output Momentary 10 seconds Timed Latched
8. Not Used
9. Remote Start in Valet Mode Disabled Enabled
10. Not Used
11. Not Used
12. Engine Run Time 12 minutes 24 minutes
13. Cold Temperature Starting Every 2 hours Every hour
14. Engine Start Sense Smart Start Tach Start
15. Engine Programming Learn RPM Gas Engine Diesel Engine
16. FM Module Program (optional) Learn Module Learn FM Transmitter
17. Ignition 2 Relay Programming Ignition 2 Accessory 2 Starter 2
18. Horn Output Horn Output Ignition 3 Output